The Samsung PM983 1.92TB U.2 PCIe Gen3 NVMe SSD 2.5" is a 1.92 TB solid-state drive on a NVMe PCIe 3.0 interface, for HPE ProLiant Gen10 / Gen11 servers.
For anything latency-sensitive — databases, virtual machines, the OS volume — an SSD is the right answer. The gap against a mechanical drive is two to three orders of magnitude in IOPS, not a few percent.
Two practical notes. First, the drive has to come in the caddy for its generation — the Gen8–Gen10 Smart Carrier and the Gen10-and-later Basic Carrier are not interchangeable, and a bare drive will not seat in a hot-plug bay. Second, in a RAID array every member should have the same capacity and speed; if one is smaller, the controller treats every disk as if it were that size.
Every drive is SMART-checked and surface-tested before it ships, and its power-on hours are disclosed.
Applications, trade-offs and selection guide
Primary storage or archive?
For databases and VMs, assess latency, IOPS and write endurance. Backup and archive decisions emphasize usable capacity, cost per TB and recovery time. The SSD label alone does not establish endurance, power-loss protection or continuous-write suitability.
Match interface and chassis
SAS, SATA and NVMe use different connection paths. Verify SFF/LFF, carrier, backplane, cables and controller. Physical fit alone does not establish electrical or firmware support.
Drive health and data protection
For used drives, request health, error history and power-on hours or total writes. RAID usable capacity differs from the sum of raw drive capacity. RAID does not replace independent backups and restore testing.
Schematic identifying the component class; not a stock-unit photograph.